PerfReal

I put videos I create on Vimeo. You can see my profile.

Basically I have tried silicone vs glue in that order from left to right on the metal mounting unit. Gorrila Glue worked far better than silicone, but I need to make something better for laying the glue and clamping the LEDs.  I also am comparing three different LEDs. There is a 50deg version of all of these that might be better. The specs are…

• model WP7113F3C (20) — This is the freq. for Wii controllers compare to recomended radioshack part # 276-143
  • 940nm
  • 20 degrees – I need to confirm that my LEDs truly match this spec.
  • 1.2-1.6V
  •  current?-
    • Results of experiments-  The unibrain doesn’t see this as well in general, I am going to try it with the wiimote as it might be better than the actual.

• model WP7113SF6C
  • 860nm
  • 20 degrees 
  • 1.35-1.6V
  • Current? max 50mz? So a 16-20ma resistor is good
  •  test result – this is the best thru the bandpass filter
  • -I believe these are the ones I used in the mount I made with Ben

• model WP7113SF7C  (10)- (I believe these are the ones I still have clustered to the board.)
  • 20 degrees 
  • 850nm
  • 1.4-1.6V
  • Current?
• IR-Cutoff Filter
  • specs
• Band Pass filter
  • specs

I should put relevant media here.